
Miniextruder
Filament maker (3devo Composer).
We play at different areas of action in terms of polymeric materials:
The Hands-on Polymers Lab has the required physical and human resources to respond to the different challenges of companies that play on the polymers field. It has capabilities to act on a variety of polymer processing technologies:

Filament maker (3devo Composer).

Single screw extruder for polymer processing. Model 19/25 D. Controller AEV331.
Temperature controller: type 808, Eurotherm.

Brabender DSK 42/7 Co-Rotating Twin Screw Extruder.
Data Processing Plasti-Corder PL2000 module.

Brabender PM-3000
Two roll-mill used for compounding (thermoplastic mixture preparation and elastomer
preparation).


Used for thermomoulding (Carver M-2089)
25ton-force, 3025ton-force
Heated plate (30 Cº - 500 Cº)


Device for analysis of the chemical structure, by infrared spectroscopy, with the possibility of utilization of a microscope. Attenuated total reflectance acessory for the analysis of powder samples, liquids, etc. Possibility for IR signal mapping.

Gel Permeation Chromatograph for the analysis of the properties of polymeric solutions, such as the molecular weight distribution of polymeric materials.

TA Instruments Q800
Dynamic-mechanical analysis for the assessment of the rheological properties of polymeric materials.
Controlled temperature furnace (-150ºC – 500ºC)
Frequency range: 0.01 to 100 Hz
Measurement cells: fixed supported bending, fixed bending, three-point bending, fibre and film tension, compression, punch penetration.

Equipment for the assessment of the melt flow index, following ASTM, D1238-62T. Useful, e.g. to compare grades within a polymer type.

Thermogravimetric analysis to assess the thermal behavior of materials. TGA is a method of thermal analysis in which the mass of a sample is measured over time as the temperature changes.

A rheometer is a device used to measure the rheological properties of materials, i.e. the flow and deformation of matter, correlating force, deformation and time. It is capable of measuring viscosity and elasticity of non-Newtonian materials under a wide range of conditions.
Normal load and binary sensors.
Controlled temperature furnace (-170Cº – 600Cº).
Measurement systems: cone and plate, parallel plates, three-point bending, solids torsion tension, uniaxial extensional flow.
Tests in stationary, dynamic and transient regimes.